皓辰团队专业维修，品质保障!!!
专业维修罗德与施瓦茨 SMB100A 微波信号发生器，其常见的故障及原因分析如下
故障点：开机报错，无法正常进入系统
原因分析：系统控制板损坏，或内部存储数据丢失，导致系统无法启动。
故障点：自检失败，输出20GHz以上时报错ALC unlocked，测试信号幅度异常
原因分析：40GHz倍频模块滤波开关故障，或内部积灰严重导致散热不良。
故障点：显示故障，如闪屏、光标乱跳等
原因分析：显示屏连接线松动或损坏，或系统逻辑控制单元故障。
故障点：OUTPUT端无输出，电源指示灯不亮
原因分析：电源故障，或电源连接线松动，导致设备无法供电。
通过了解设备的常见故障，您可以更好地维护和使用它，确保其长期稳定运行。若无法解决，欢迎联系晧辰！我们的维修团队拥有丰富的实战经验和专业的维修流程，可为您提供快速、可靠、优质的维修服务！
Hao Chen team professional maintenance, quality assurance!!
Professional maintenance of Rohde & Schwarz SMB100A microwave signal generator, its common failures and reasons are analyzed as follows
Fault point: An error occurs when the system is powered on and cannot enter the system normally
Cause: The system control board is damaged or internal data is lost. As a result, the system fails to start.
Point of failure: The self-test failed, the output above 20GHz is incorrectly unlocked, and the test signal amplitude is abnormal
Cause analysis: The filter switch of 40GHz frequency doubling module is faulty, or the internal ash seriously leads to poor heat dissipation.
Fault point: A fault is displayed, such as a blinking screen or cursor skipping
Cause analysis: The display cable is loose or damaged, or the system logic control unit is faulty.
Fault: There is no OUTPUT on the output end, and the power indicator is off
Cause: The power supply is faulty or the power cable is loose. As a result, the device cannot supply power.
By understanding the common faults of the equipment, you can better maintain and use it to ensure its long-term stable operation. If you can not solve, welcome to contact Hao Chen! Our maintenance team has a wealth of practical experience and professional maintenance process, can provide you with fast, reliable, quality maintenance service!
Copyright © 2007 All Rights Reserved. 深圳市晧辰电子科技有限公司 版权所有 [粤ICP备14101712号-1] [法律顾问]
公司地址：广东省深圳市南山区南山智谷产业园F座1402 邮编：518055
