Product Description:
a, the power supply voltage must be less than 12V and greater than 4.4V, otherwise the probe may be damaged or cannot operate normally.
B, the polarity is "+" inside and "-" outside. If the polarity is wrong, the built-in circuit protects the probe from danger or damage.
C. When the battery voltage is too low, the power indicator on the panel blinks.
Product features:
Bandwidth DCto 100MHz (-3dB)
Attenuation ratio 1:100/1000
Accuracy ±2%
Rise time 3.5ns
Input impedance 4MΩ//7pF each side to ground
Input voltage
- Category Three.
- Difference range ±140V (DC + AC peak) and 140Vrms @1/100
±1400V (DC + AC peak) and 1000Vrms @1/1000
- Total model range ±1400V (DC + AC peak) and 1000Vrms @1/100 and 1/1000
- Absolute maximum. voltage
(Difference or common mode)
±1400V (DC + AC peak) and 1000Vrms @1/100 and 1/1000
Output voltage
- Swing ± 1.4V (into 50kΩ load)
- Offset (typical) <±5mV
- Noise (typical) 0.9mVrms
- Source impedance (typical) 50Ω (for use with 1MΩ input system oscilloscopes)
CMRR (typical) -80dB@60Hz; -50dB @ 1MHz
Ambient operating temperature -10 ~ 40℃
Ambient storage temperature -30 ~ 70℃
Ambient humidity up to 85% RH.
Ambient humidity: RH≥85%.
Claims *
- Standard 4xAA battery
-- option
Power leads, power adapters *
(6 volts DC / 200 ma
Regulated voltage 9VDC/120mA), USB power cable
Input lead length 30cm
The length of the BNC lead is 92.5cm
Weight: 500 gms
Dimensions (length, width and height) 207mm × 83mm × 38mm
