Product introduction:
The FSQ26 is a 26.5 GHz signal analyzer manufactured by Rohde & Schwarz. Engineers use the ability of a signal analyzer to combine spectrum and vector signal analyzers. A signal analyzer is an electronic testing device used to measure the power, amplitude, distortion, phase noise, modulation and demodulation quality of an input signal.
Features:
-
The signal analysis bandwidth is 28mhz
-
Phase noise :typ. -133 dBc (1 Hz) at 10 kHz carrier offset, carrier frequency 500 MHz
-
Distortion :1 Hz
-
Reference frequency: Aging :1 x 10-7 / year, R&S®FSU-B4 Options :2 x 10-8
-
DANL (R&S®FSU-B25) with preamplifier, 1ghz, 1hz RBW: -162 DBM
-
Trace detector: maximum peak, minimum peak, automatic peak, sample, root mean square, average, quasi-peak
-
Total measurement uncertainty f < 3.6GHz: 0.3dB
-
Display linearity :0.1 dB (0 dB to -70 dB)
-
Interface :GPIB or LAN interface
-
Sampling rate: Programmable :10 kHz to 81.6 MHz in 0.1 Hz steps
-
ADC resolution :14 bits
-
I/Q memory: 16 Msample for I and Q data
-
Impedance :50Ω
-
Connector :testport adapter 2.92 mm (K)/N female hole
-
Attenuator setting range: 0-75 dB, 5 dB level
-
Display: 21cm LCD TFT Color Display (8.4 in)
-
Resolution :800×600 pixels (SVGA resolution)
-
Pixel failure rate :< 1×10-5
-
Large capacity memory: hard disk, u disk (not available)
-
Data storage :> 500 instrument setup and tracking
-
Ac power supply :100v to 240v, 3.1A to 1.3A; 50hz to 400hz, protection level I to VDE 411
-
Energy consumption :typ. 150 years Virginia
-
Safety: In accordance with en61010-1, IEC 61010-1, UL 61010-1, CAN/CSA-C22.2 No. 61010-1-4
-
Test marks :VDE, GS, CSA, CSA-nrtl