特点:
适用于DL750/DL750P&SL1400
随着近年来测量信号速度的提高,使得必须要在宽频带上实现浮动测量。700924差分探头通过将探头连接到单端输入信号示波器的输入上,实现宽频带(100MHz)差分输入测量。
示波器输入放大器通常为单端。当与10:1无源探头结合使用,对切换电源的栅源电压,或元件如绝缘门双极晶体管(IGBTs)中的共模电压的电位差进行测量时,不提供精确测量。
此外,电流进入示波器接地线,有损坏示波器的风险。
规格 |
|
输入类型 | 平衡的差分输入 |
频宽 |
DC到100MHz (-3dB) |
输入衰减率 |
在1/100和1/1000之间切换 |
输入阻抗 |
约4MΩ,约10pF并联 |
增益精度 |
±2%(共模电压:400V或更少) ±3%(共模电压:1000V或以下) |
最大允许 差分电压 |
±350V (DC+AC峰值)或250Vrms (1/100量程) ±1400V (DC+AC峰值)或1000 Vrms (1/1000量程) |
最大共模 输入电压 |
±1400V (DC+AC峰值)或1000Vrms (1/100和1/1000量程) |
最高输入电压 |
±1400V (DC+AC峰值)或1000Vrms (1/1000量程) |
共模抑制 比(CMRR) |
-80dB (60Hz),-50dB (1MHz) |
输出电压 |
±3.5V |
输出阻抗 |
使用1MΩ输入阻抗 |
电源 |
干电池,四节R6P(SUM-3); 当使用AC/DC适配器,使用6V/200mA或更高/中心正号的输出电压 |
干电池寿命 |
持续使用约2小时 |
外部尺寸 (约) |
207mm x 83mm x 38mm1 |
总长 |
约1.5米 |
重量 |
约800g (包括干电池) |
符合标准 |
EMC:EN55011:1991 + A1:1997+A2:1996 EN50082-1:1992 安全:EN61010-1:1993+A2:1995 EN61010-2-031:1994 |
Suitable for DL750/DL750P&SL1400
As the speed of measurement signals has increased in recent years, it has become necessary to implement floating measurements over a wide frequency band. The 700924 differential probe realizes wideband (100MHz) differential input measurement by connecting the probe to the input of a single-ended input signal oscilloscope.
The oscilloscope input amplifier is usually single-ended. When used in conjunction with a 10:1 passive probe to measure the gate-source voltage of a switching power supply, or the potential difference of common-mode voltages in components such as insulated gate bipolar transistors (IGBTs), accurate measurements are not provided.
In addition, the current enters the oscilloscope ground wire, which may damage the oscilloscope.
specification
Input type
Balanced differential input
bandwidth
DC to 100MHz (-3dB)
Input attenuation rate
Switch between 1/100 and 1/1000
input resistance
About 4MΩ, about 10pF in parallel
Gain accuracy
±2% (common mode voltage: 400V or less)
±3% (common mode voltage: 1000V or less)
Maximum allowable
differential voltage
±350V (DC+AC peak) or 250Vrms (1/100 range)
±1400V (DC+AC peak) or 1000 Vrms (1/1000 range)
Maximum common mode
input voltage
±1400V (DC+AC peak) or 1000Vrms
(1/100 and 1/1000 range)
Input voltage
±1400V (DC+AC peak) or 1000Vrms (1/1000 range)
Common Mode Rejection
Ratio (CMRR)
-80dB (60Hz),-50dB (1MHz)
The output voltage
±3.5V
Output impedance
Use 1MΩ input impedance
power supply
Dry battery, four R6P (SUM-3);
when using AC/DC adapter, use 6V/200mA or higher/center positive output voltage
Dry battery life
Continuous use for about 2 hours
External dimensions
(approx.)
207mm x 83mm x 38mm1
Total length
About 1.5 meters
weight
About 800g (including dry battery)
Standards compliant
EMC: EN55011: 1991 + A1: 1997+A2: 1996
EN50082-1: 1992
Security: EN61010-1: 1993+A2: 1995
EN61010-2-031: 1994
Copyright © 2007 All Rights Reserved. 深圳市晧辰电子科技有限公司 版权所有 [粤ICP备14101712号-1] [法律顾问]
公司地址:广东省深圳市南山区西丽街道官龙村华纵科技楼5楼 邮编:518055
在线QQ服务: 服务热线:0755-86016691 电话:13715327187 传真:0755-86641139-816
E-mail:info@wl95.com